Carbon Fiber Reverse Lamp Overlay - 2020+ Supra

• 3D Carbon Fiber overlay for the factory reverse lamp on the 2020+ Toyota GR Supra (A90)
• Designed for the stock reverse lamp housing — the rectangular lamp that OLM converts to a brake light
• Can technically fit other aftermarket lamps with a flat surface, but will reduce light output slightly on those
• 2-piece set — both pieces shown in photos
• Built-in air egress channels for bubble-free installation
• Made and cut in the USA by StickerFab

Carbon Fiber the Factory Reverse Lamp on Your Supra

The factory reverse lamp on the 2020+ Toyota GR Supra is a rectangular-ish housing that sits in the lower bumper,  This 3D Carbon Fiber overlay gives it a premium carbon look that ties into the rest of the car without any modification. The cutout pattern preserves the visibility of the LED array through the overlay while adding carbon texture around it.

Designed specifically for the stock reverse lamp. On the stock setup (reverse function only) light transmission is good — the carbon material allows the white reverse light to show clearly.  Ships as a 2-piece set with air egress channels built into the adhesive for a clean, bubble-free install. Made in the USA.

Features

• 3D Carbon Fiber texture.
• Built-in air egress channels — prevents bubble trapping
• 2-piece set
• Made and cut in the USA

Installation

1. Clean the lamp lens surface thoroughly — remove all dirt, wax, and debris
2. Mix one drop of dish soap with a cup of water and mist the adhesive and lens surface
3. Center the overlay and press from the middle while keeping the edges lifted
4. Once aligned, push water and air out from center to edges
5. Use a hair dryer on low to dry and increase adhesion — once dry, the adhesive becomes very sticky

Fitment

Fits: 2020+ Toyota GR Supra A90 — designed for the factory reverse lamp housing. Can technically fit other aftermarket lamps with a flat surface, but will reduce light output slightly on those applications. Not designed for factory tail lights.

FAQ

Will this block the reverse light output?
On the stock reverse lamp (white reverse function), the carbon material with cut outs allows clear light transmission — the white light shows through well. 

Is this the same overlay as the F1 lamp versions?
No — this is cut for the factory reverse lamp housing, which has different dimensions than the OLM F1 lamp. The F1 overlays are separate listings.

How many pieces are included?
2 pieces — both pieces shown in the product photos.

Do these have air channels like the other overlays?
Yes — built-in air egress channels prevent bubbles from trapping. The wet install method combined with the channels makes alignment and installation forgiving.